21-GB
Copying CD text
information while
recording (Joint Text)
By connecting the recorder to a Sony
portable CD player that supports Joint
Text (the CD text copying function) (D-
EJ01), you can copy track and disc names
automatically during recording. In
addition to the CD text connecting cable
(RK-TXT1), make sure to connect the
recorder to the portable CD player with an
optical cable.
1 Slide REC to the right to start
recording on the recorder, and start
playing the CD in the portable CD
player.
“SYNC”, “REC” and “” lights up
in the display.
“CD TEXT” appears for a few
seconds, then “001 TEXT?” and
“PushENTER” alternate in the
display.
“NO TEXT” appears at this time if no
track name information exists in the
CD. In this case, the track name will
not be copied.
2 Press the jog lever.
Track name scrolls, and then the track
name and “PushENTER” alternate in
the display.
3 Press the jog lever.
Track name scrolls in the display
while the name is copied.
4 Follow steps 2 and 3 to copy each
new track name that appears.
5 Press x on the recorder at the point
you want to stop recording.
“” lights up, and then “000
TEXT” and “PushENTER” alternate
in the display.
If you don’t want to copy the disc
name information, press x again. The
disc name is not copied and the
operation ends.
“NO TEXT” appears at this time if no
disc name information exists in the
CD. In this case, the operation ends
without copying the disc name.
6 Press the jog lever.
Disc name scrolls, and then disc name
and “PushENTER” alternate in the
display.
CD text connecting cable,
CD that support CD-TEXT,
and CD player that support
Joint Text required
Jog lever
To i/
LINE OUT
jack
x
REC
To LINE IN (OPTICAL) jack
RK-TXT1
(not supplied)
Portable CD player
(D-EJ01)
To LINE OUT
(OPTICAL)
jack
POC-5B
etc. (not
supplied)
To i/REMOTE
jack
continued
To Next Page
Loading...
Need help?
General