– 21 –
MW Auto Scan/Stop Level Adjustment
Setting:
[SOURCE] n [MODE] buttons : MW
Procedure:
1. Set to the test mode. (See page 18)
2. Push the [SOURCE] button and set to FM.
3. Push the [MODE] button and set to MW.
Display
4. Push the preset
[3] button.
Display
5. Adjust with the volume RV1 on TUX10 so that the “MW”
indication turns to “MW0” indication on the display window.
But, in case of already indicated “MW0”, turn the RV1 so that
put out light “0” indication and adjustment.
Display
Adjustment Location: See page 22.
AM RF signal
generator
Carrier frequency : 999 kHz
30% amplitude
modulation by
1 kHz signal
Output level : 33 dB (44.7
To Next Page
Loading...
Need help?
General
