4SG 310/330 Rev. 2
Operating Instructions
Traffic on interface
Executable Actions
Ì Change IP Address: This option enables the user to change the interface’s IP
address and netmask. All available and enabled IP addresses can be changed.
Ì Reboot machine: The security appliance is rebooted. The reboot
action will shut down the system completely and reboot.
Ì Shut down: The security appliance is shut down. The shut down action allows
you to turn off the system, and allows you to cleanly stop all running services.
Ì Factory reset: All settings are reset to the factory settings. The factory
reset function sets all of the configuration settings and options to their
original state. All data entered after the initial installation will be deleted,
including the HTTP proxy cache, the entire email queue, accounting
and reporting data, passwords, and uninstalled Up2Date packages.
The version of the software will not change. That is, all firmware
and pattern updates that have been installed will be retained.
Ì Disable OTP (One Time Password) authentication: The OTP
authentication will be disabled for the selected options. This feature
only handles webadmin and shell access options if they are enabled.
Sophos UTM version and Appliance Uptime
CPU load information and Average Load in the last 1, 5 and 15 minutes
Memory usage
LCD and Control Keys
The Sophos SG 310/330 units have an LCD and an operating unit with four
membrane keys. In the LCD, 16 characters per line can be displayed. The display
contains in four cycling views information on the hardware and specific system
states.
After the security appliance has booted this message is displayed.
SOPHOS
Protection
UTM 9.xxx
10 days 01:43:17
CPU xx%
xx% yy% zz%
RAM x% y GB
SWAP x% y GB
all in x kbits/sec
out y kbits/sec
To Next Page
Loading...
Need help?
General
