15
E.2 Commissioning help
Parametrisation
1. Set language, time and date
2.a) Start setup wizard (menu 6.8.) The setup wizard
guides through the necessary basic settings in the
correct order. Every parameter is briey explained in
the display. Pressing the „esc“ key takes you back to
the previous setting.
or
2.b) without setup wizard: The settings should be made in the following order:
• menu 9. Language.
• menu 2. Time, Date and Operating Times.
• menu 3. Heating Circuit Settings, all values.
• menu 5. Protection Functions (if any adjustments necessary).
• menu 6. Special Functions (if any adjustments necessary).
NB: The setup wizard can always be selected in Menu 6.8.
Caution: Consider the explanations for the individual parameters on the following pages
and check if further settings are necessary for your application.
3. In Menu 3.2, the operating mode should be set to ‚Manual‘ to test the switch outputs with the
consumers connected and check the sensor values for plausibility. Then set to automatic mode.
To Next Page
Loading...
Need help?
General