39
Caution
This menu is used to set the current time and date.
When this function is active, the controller’s clock changes automatically to and from
DST (DST, Daylight Savings Time).
6.11. - Time and date
6.12. - Daylight saving time
For analysis of the system data it is essential for the time to be set accu-
rately on the controller. Please note that the clock does not continue to
run if the mains voltage is interrupted, and must therefore be reset.
When active, the displays backlight is switched off after 2 minutes of inactivity.
6.13. - Eco display mode
Caution
If a message is waiting, the backlight is not switched off.
This menu is used to select the temperature unit that is displayed.
6.14. - Temperature unit
6.15. - Network
6.15.1. - Access Control
6.15.2. - Ethernet
In this menu, the settings of the Ethernet connection of the data logger are set.
Activate oder deactivate the ethernetfunction.
6.15.2.1. - Ethernet
6.15.2.4. - IP-Adress
6.15.2.5. - Subnet
6.15.2.6. - Gateway
6.15.2.2. - MAC Adress
6.15.2.7. - DNS-Server
6.15.2.3. - Auto-Con guration (DHCP)
In this menu, the settings of the ethernet connection of the data logger can be set.
Displays the individual MAC address of the data logger.
In this menu, the IP of the gateway for the data logger can be set.
In this menu, the IP address of the data logger can be set.
In this menu you can add or remove four users who should have access to the data log-
ger. ITo add a user in the list, select <add user>. The list show you the last 5 users that
tried to connect to the data logger. Select a user with OK to give it to grant access. To re-
voke access again choose one of the 4 users from your list and choose <remove user>.
If activated, the datalogger requests IP adresses and network parameters from a DHCP
server.
In this menu the subnet mask of the data logger can be set.
In this menu, the IP address of the DNS server can be set.
Special functions
To Next Page
Loading...