25
This voltage is put out when the pump is turned off (Pumps that can detect cable break
need a minimum voltage).
This voltage is needed to turn the pump on at minimum speed.
This determines the output voltage for the highest speed of the pump, that is used e.g.
during purging or manual operation
Displays the set signal in text and a graphical diagram.
Special functions
6.2.4. - 0-10V / PWM off
6.2.5. - 0-10V / PWM on
6.2.6. - 0-10V / PWM max
6.2.7. - Show signal
To Next Page
Loading...
Need help?
General