Sorel MTDC - CAN-Bus

46
Additional Information
Z.4 CAN-Bus
Controller 1 Controller 2 Controller 3 Controller n
Datalogger (valgfrit)
The CAN bus can be used to connect two or more controllers with each other or with the
data logger to exchange data.
(1) (1) (1)
(1)
(2)
(2)
(3)
1. The controllers are connected in series with the CAN bus cable (1).
2. The  rst and last controller/data logger in this connection series must be  tted with
a terminating resistor (2).
The wiring of the two CAN sockets is optional.
3. Optionally, the data logger (3) can be integrated in a CAN bus.
The available CAN functions are subject to the controller type as well as the software
version used and can be seen in the corresponding manual.