Ui12, Ui16 User Manual
10.1.1: HOTSPOT
SETTINGS > NETWORK CONFIG > HOTSPOT
10.1.1: HOTSPOT SETTINGS
Use the Save/Update button to save Hotspot settings.
IMPORTANT: You must recycle the Ui power (turn the unit off and on) for settings to take effect.
The Ui has it’s own hotspot, so it can create it’s own network so other devices can connect to it and
access the software in it’s built-in webserver. Select the Hotspot Conguration menu in Network Cong
to edit the Hotspot settings.
Hotspot
Enabled / Disabled
Enable or disable the UI’s own Hotspot. Please note, if the Hotspot is disabled you will need to connect to the Ui via
either an existing Wi-Fi network, or a wired LAN connection (Ethernet).
SSID (Service Set Identier)
Text Entry
This is the name of the Ui Hotspot. The default is ‘Soundcraft Ui’
Wireless Regulatory Domain
Region Selection
Select the correct region - you current location. This will help select the correct channel selection.
Channel
Channel Selection
A number of channels are available within the Wi-Fi spectrum, depending on the Regulatory Domain. There is
third-party software available to help you select a local Wi-Fi channel.
Security
None / WPA2
Choose either no security, or WPA2 (Wi-Fi Protected Access II) protection. IN the latter case, you will have to choose
a password.
To Next Page
Loading...
Need help?
General
