CROSSOVER ADJUSTMENTS
The Tarantula amplifier incorporates two separate electronic crossovers. A 12dB\octave Subsonic
filter and an on-board 24 dB\octave electronic low pass crossover, with full range RCA outputs to
drive an external amplifier. No external electronic crossover is required when operating this amplifier.
Subsonic
The Subsonic filter allows the amplifier to focus all of its energy where it is needed most. Adjust the
filter to the tuning frequency of a ported box and increases in output will be noticed immediately. The
Subsonic filter is variable from 13 to 30 Hz.
The shaded area below shows the frequency and range adjustments as they appear on the control
panel of the amplifier.
Low Pass
The Low Pass filter is variable from 35 to 500 Hz, which is divided into two separate ranges: “Low” and
“High”. The “Low” range will yield a frequency range from 35 to 135 Hz, while the “High” is from 135 to
500 Hz.
The shaded area below shows the frequency and range adjustments as they appear on the control
panel of the amplifier.
11
To Next Page
Loading...
