EasyManua.ls Logo

Soundstream Tarantula - Features P

Soundstream Tarantula
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FEATURES
RUBI (Rapid-Use Branched Impulse) This new proprietary power supply topology eliminates “power
sags"during low frequency reproduction by rapidly increasing the duty cycle, stabilizing the power
supply and allowing it to deliver the power required when reproducing low frequencies. Also, greater
reserve gate power is stored for low voltage conditions that occur during extreme conditions.
STACT™(STabilized Apex Current Topology) Reduces power supply stress by 50%. In The STACT
design, inversion is done at the power amplifier drive stage. Since the fully symmetrical power amplifier
produces no even-harmonic distortion itself and all preamplifier circuitry is run completely inphase,no
even harmonic distortion phase reversal occurs and power is better distributed throughout the amplifier.
Advanced Trident™ Protection Topology Protects against potential harm/damage in the following
situations:
1. Output Protection against short circuits or improper loads.
2. Voltage Inconsistencies protects against ground fault (speaker shorts to vehicle chassis) and an
under/over voltage condition on the battery input.
3. Thermal Protection puts the amplifier into thermal rollback or shuts the amplifier down in extreme
thermal conditions.
Tone Sweep Calibration Routine Automatically configures and optimizes the power supply to the
connected speaker load.
Hawkins Bass Control Provides a focused parametric subwoofer boost (0 to +9 dB between 13-70 Hz)
and routes otherwise wasted amplifier power back to the audible bandwidth.
Continuously Variable Crossover Networks 24 dB/octave low pass crossovers variable from 35 Hz to
500k Hz with a range selection switch.
Input Level Indicator A three colored LED that provides visual confirmation of the amplifier’s input level
sensitivity setting.
Output Clipping Indicators Indicates clipping on the output stage of the amplifier. Monitoring the clipping
indicators allows the user to achieve maximum SPL without clipping the amplifier.
Large Mouth Bass Remote subwoofer volume control built into the amplifier
4

Related product manuals