FEATURES
Output Phase Switch O-180 degree phase control switch.
Fan Cooling With thermally sensitive speed control.
Differentially Balanced RCA Input Eliminates ground loop related noise in the audio signal.
Fully Balanced 6-pin DIN Input For professional quality performance and noise cancellation. The 6-pin
DIN plug carries (
) signal information for left and right channels, audio ground, and 15Vdc to
operate the Soundstream BLT/ BLT4 Balanced Line Transmitters and Balanced X.0 crossover.
RCA Line Output Provides a full range signal output to drive other amplifiers.
Wire Connections Power and ground connections accept 1\0 gauge cable, while the speaker
connections utilize dual 4 gauge connections.
Harmonic Bass Alignment™ The 2nd and 3rd order harmonic peaks are critically aligned to
fundamental peaks at low frequencies. This produces tighter,more accurate bass reproduction.
Symmetrical Discrete Balanced Class A Drive Boards Auto-adjust for linear performance while driving
low impedance loads.
Drive Delay II™ Amplifier section powers up 2 to 3 seconds after the power supply, eliminating turn-on
pops. Turn off process is reversed; amplifier section turns off first, followed by the power supply.
Chassisink™ All transistors are ideally located and sandwiched between the circuit board and the
heatsink to provide cool efficient amplifier operation.
Dynamically Optimized Power Grid™ Power grid is evenly distributed between primary and secondary
power supplies, providing greater dynamics and improved RF filtering.
5
To Next Page
Loading...
