EasyManua.ls Logo

Southbend 500 Series User Manual

Southbend 500 Series
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Job Item#
www.yatesgd.com www.yatesgraphicdesign.com
500 SerieS
reStaurant range
10 Open Burners, Double Ovens
or 6 Open Burners and 24” Griddle
Printed in USA
Standard Oven - 560DD
Convection Oven - 560AA
Standard Oven with 24” Griddle - 560DD-2G/T
Convection Oven with 24” Griddle - 560AA-2G/T
STANDARD CONSTRUCTION SPECIFICATIONS
Exterior Finish: Bright annealed front rail and valve panel.
Stainless steel front, trim, kick panel and sides.
RangeTop:- 10 each, 27,000 BTU NAT (24,000 BTU LP) cast
iron burners round, non-clogging design, Center-to-center
measurements between burners not less than 12”, side-to-side
or front-to-back. A removable one piece stainless steel drip tray
is provided under burners to catch grease drippings
Door: Constructed with heavy duty hinges and quadrants and
2” ergonomically designed, “Cool Touch” chrome handle
Standard Models (560D)
Interior: 45,000 BTU NAT (40,000 BTU LP) Blue porcelain
enamel interior and door lining. Fully insulated oven cavity.
Rack and Rack Guides: Five rack positions with two racks.
Controls: Oven thermostat temperature type adjustable for
250° - 500° F with a low setting.
Pressure Regulator: Factory installed.
Convection Models (560A):
Interior: 32,000 BTU NAT (30,000 BTU LP) Blue porcelain
enamel interior and door lining. Fully insulated oven cavity.
Rack and Rack Guides: Heavy duty, 5 position rack guides on
2-3/8” centers with 2 removable plated racks. (For best results,
no more than 3 racks should be used)
Blower Fan and Motor: 1/2 hp, 1725 rpm, 60 cycle, 115V AC,
high efciency, permanent split phase motor with permanent
lubricated ball bearings, overload protection and Class B
insulation. Motor mounted to rear of oven. Motor serviceable from
front of oven through oven cavity.
Electrical System: Wired for single phase, 115V AC with 6’ cord
and 3-prong plug supplied with each deck.
Gas Control System: Includes pressure regulator, ame switch
safety, pilot lter, pilot adjustment
Oven Heating: Aluminized steel bar burner. Dual ow fan
recirculates heat directly from combustion area and within oven
cavity.
Controls: Oven thermostat temperature type adjustable for
250° - 500° F with a low setting.
560 Rev 2 (June/2009)
Standard Features
- Cast iron wavy grate with cast-in-bowl and 15” rear section
- Electronic ignition
- Manual gas shut-off to entire range
- 6” casters - 2 locking, 2 non-locking
- 22-1/2” riser with removable stainless steel shelf
- 27,000 BTU NAT (24,000 BTU LP) non-clogging burners with
lifetime warranty
- 10 patented, non-clogging, cast iron burners
- 5-1/2” Bright annealed front rail and valve panel
- Commercial gas range 36-1/2” wide with a 37” cooking top
(including 6” high casters)
- Removable stainless steel one-piece drip tray under burners
- Stainless steel front, trim, kick and sides
- 2” ergonomically designed, “Cool Touch” chrome door handle
- Two year Parts and Labor Warranty
Griddle
- 24” griddle with 1/2” polished steel plate
with (4) 16,000 BTU (NAT or LP) burners
Common Oven Features
- Equipped with electronic ignition and ame failure safety device
- Blue porcelain interior and door lining
- Five rack positions
- Full size sheet pans t side-to-side or front-to-back
- Lift-out oven bottom and coved interior
- Fully front serviceable
- Thermostat range from 250°- 500°F (121°- 260°C) with
low setting
StandardOven(Dsufx) ConvectionOven(Asufx)
- 45,000 BTU NAT (40,000 BTU LP) - 32,000 BTU NAT (30,000 BTU LP)
- On/Off switch to allow CO
base to operate as Standard oven
Question and Answer IconNeed help?

Do you have a question about the Southbend 500 Series and is the answer not in the manual?

Southbend 500 Series Specifications

General IconGeneral
Model500 Series
Fuel TypeNatural Gas or Propane
Burners4
Oven TypeStandard
ConstructionStainless Steel
Width32" to 72"
Number of Burners4

Summary

Standard Features

Standard Construction Specifications

Exterior Finish

Bright annealed front rail/valve panel. Stainless steel front, trim, kick panel and sides.

RangeTop

10 cast iron burners, non-clogging, 12" center-to-center, removable drip tray.

Door

Heavy duty hinges, quadrants, 2" "Cool Touch" chrome handle.

Rack and Rack Guides

Five rack positions with two racks for Standard models.

Blower Fan and Motor

1/2 hp motor, 1725 rpm, 115V AC, serviceable from front.

Electrical System

Wired for single phase, 115V AC with 6' cord and 3-prong plug.

Gas Control System

Includes pressure regulator, flame switch safety, pilot filter.

Oven Heating

Aluminized steel bar burner, dual flow fan for heat recirculation.

Controls

Oven thermostat adjustable for 250°-500°F with a low setting.

Pressure Regulator

Factory installed.

Dimensions

Exterior Dimensions

Width, depth, and height specifications for different models.

Oven Interior Dimensions

Interior width, depth, and height for the oven cavity.

Burner and Griddle Details

BTU ratings for burners and gridle size specifications.

Utility Information

Gas Specifications

Total BTU ratings for natural gas and LP, required supply line size.

Electrical Specifications

Voltage, amperage, and cord details for standard and optional models.

Options and Accessories

Burner and Shelf Options

24" griddle in lieu of burners, 6" legs, flue riser, and shelving options.

Hose and Safety Options

3/4" quick disconnect hose, flame failure on open tops.

Additional Equipment

Cheesemelter, salamander broiler, extra oven racks, standing pilot.

Related product manuals