Assembly Steps 1-2
4
M5x25 + WASHERS (4 Units)
Front
A
1
Remove the parts from the box.
Note that the base and gantry are
connected at the factory. If possible,
perform this operation with the help
of another. Remove any tape and
padding from the parts. Inspect the
parts to make sure they were not
damaged in shipment.
Install the gantry (A) to the base (B).
a) On the gantry frame make sure
the nozzle assembly is in to the
front, and the long vertical leads
screws is in to the back.
b) On the base frame, make sure
the black belt tensioner is on the
front, and the stepper motor is on
the back.
Use the M5x25 screws (4) with their
washers. Lift the base frame. Install
the screws through the base frame
into the threaded holes in the gantry
frame. Tighten with an Hex key
(Allen). Do not exceed tightening to
avoid deformations in the frame.
1
2
2
B
04
Front
4mm
To Next Page
Loading...
