If this is the rst me operang the machine, you MUST clean and sanize ALL parts prior
to running the machine.
• Daily
• Every 1 to 3 months*
• Quarterly**
* Based on machine usage and cleaning intervals; a Tune-Up Kit is available with all
wearable parts (O-rings, gaskets, etc.) except scraper blades.
** Based on cleanliness of locaon and proximity to powder-based machines.
Preventave maintenance includes cleaning condensers, checking belt tensions,
and cleaning the interior of the machine frame as required.
Cleaning and sanizing schedules are governed by state or local regulatory agencies and
MUST be followed accordingly. Roune maintenance MUST be performed a minimum of once every
three days.
• Do NOT run the machine without properly lubricang required parts
• Do NOT clean the machine with abrasive or toxic chemicals and cleaners. Doing so may cause
damage to the stainless steel material
• ONLY use Spaceman-included cleaning brushes and lubricaon
• NEVER use metal objects to clean or operate the machine
• ALWAYS replace wearable parts a minimum of every 3 months
• ALWAYS prime machine prior to operang
• ALWAYS inspect parts for excess wear and damage
Addional brushes, lubricaon, wearable parts, and tools can be purchased from Spaceman to
ensure proper maintenance. Extra wearable parts (except scraper blades) are found in the Start-Up
Kit.
Aer unpacking and inspecng the parts, you are ready to disassemble the machine and prepare for the rst
operaon.
For opmal machine performance and many years of eciency and reliability from your machine, Spaceman
recommends cleaning and sanizing the machine and its parts .
The image displayed is for illustraon purpose
only and may dier from the actual product.
To Next Page
Loading...
