Fill Assembled Unit for Use
27
I
FILL ASSEMBLED UNIT FOR USE
TO FILL WITH WATER:
1. Roll the completed assembly to desired
location.
2. Tighten both base caps (23) and base cap
gaskets (45) securely into place.
3. Fill the base with water (approx. 129 l / 34
gal).
4. Push in the cap (24) securely.
#24
#45
#23
CAUTION
ADD AT LEAST TWO GALLONS (7.6 LITERS) OF NON-TOXIC ANTIFREEZE IN SUB-FREEZING CLIMATES.
CHECK WATER LEVEL BEFORE EACH USE!
TO FILL WITH SAND:
1. Roll the completed assembly to desired
location.
2. Carefully tip the system forward.
3. Fill the base with sand (approx. 181 kg /
400 lb).
4. DO NOT LEAVE THE SYSTEM
UNATTENDED!
5. When the base has the appropriate
amount of ballast, tighten both base caps
(23) and base cap gaskets (45) securely
into place.
6. Push in the cap (24) securely.
7. Carefully upright the system.
#45
#24
S
A
N
D
IMPORTANT
No matter which hole is used for lling, BOTH caps MUST be tightened COMPLETELY and SECURELY to prevent leakage.
NOTE
IF USING SAND: ANTIFREEZE IS NOT REQUIRED.
To Next Page
Loading...
