User’s Manual
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 07/10
98
Otherwise, the <Device Setup> setting is completed.
NOTE: After changing any item under Device Setup menu, users
MUST set <Apply> to <Yes> to apply the changes, or the settings will
remain unchanged.
5.3.2.8 Activated
Access this item and select <Yes> to activate the connection to the IP camera.
To deactivate the connection, select <No>
NOTE: Once the connection to the IP camera is activated, menu items
<Hostname/IP>, <Model>, <Connection Setup> will be grayed out and
cannot be accessed.
5.3.2.9 Status
After the connection to the IP camera is activated, users can check the
connection status. The menu will be shown as below
Status
Model
Resolution
PPS
Bandwidth
Pkg. lost rate
****
720*480
10
20 KB/Sec
0.1%
The information shown on the monitor is “ready only”.
5.3.2.10 Copy Settings
This item allows the user to copy the settings set on the current selected
camera to any other connected cameras. Enter this menu and select one or
more cameras to copy the settings. Then select <CONFIRM> to apply the
settings.
Copy Settings
COPY TO:
10 11 12 13 14 15 16
SELECT ALL DESELECT ALL CONFIRM CANCEL
To Next Page
Loading...
