Installing or Replacing a Power Supply
4
1. Prepare the library—Access the back of the library.
a. Remove the screws securing the cover plate using a #2 Phillips screwdriver.
b. Set the plate and screws aside.
2. Install the power supply—Slide the new power supply straight into the opening.
a. Gently push the power supply in until it fully seats itself in the library.
b. Secure the power supply by tightening the finger screws.
c. Connect the power cord.
Note: Connect each of the library’s AC inputs to a separate circuit. Using
separate circuits allows for failover in the event of a power failure
in one of the circuits. The failover feature requires the N+1 power
redundancy option.
Your power supply is installed and you can resume operation.
Figure 1 Power supply cover plate.
Figure 2 Power supply connections.
Finger
screws (3x)
Power
cord
To Next Page
Loading...
