Spectra T50e - Page 5

Installing the Power Supply
5
Replacing an Existing Power Supply
Follow these steps to replace the single power supply (see Figure 1 and Figure 4).
1. Prepare the library—Ensure that the library is not performing a task by observing
that the BlueScale User Interface on the front panel is idle.
a. Press the front panel power button. The power-off sequence takes
approximately two minutes while the library allows applications to shut down
gracefully.
b. Access the back of the library and disconnect the power cord.
2. Remove the power supply—Loosen the finger screws by hand or with a
#2 Phillips screwdriver and slide the power supply straight out of the library.
Note: After removing the new power supply from its packaging, keep the
packaging to return the old power supply to Spectra Logic.
Figure 2
Figure 3 Power supply replace–power off the library.
Figure 3
Figure 4 Remove the power supply.
Power button
Finger
screws
Redundant
power supply
cover
Slide the power supply
straight out of the library.