Installing or Replacing a Power Supply
6
3. Install the replacement power supply—Slide the new power supply straight into
the library.
a. Secure the power supply by tightening the finger screws.
b. Connect one end of the power cord to the power supply and the other end to an
outlet.
c. Press and hold the front panel power button for two to three seconds to power
on the library. Wait while the library completes its power-on sequence, which
takes from six to nine minutes depending on your library configuration.
4. Package the power supply module and ship it to Spectra Logic as described in
Returning Components below.
Restarting Backups
If necessary, use your backup software to restart any backups that were stopped when
the power supply malfunctioned.
Returning Components
After you complete the replacement procedure, return the malfunctioning power
supply (component) to Spectra Logic.
Packaging a Component for Shipment
Note: Use the packaging from the replacement component to pack the
component you are returning. The packaging may look somewhat
different from that shown in this section.
1. Place the component inside the anti-static bag.
To Next Page
Loading...
