Returning Components
7
2. Fold the bag snugly around the component and tape it closed (see Figure 5).
3. Place the bottom air cushion, plastic side up, in the shipping box.
4. Place the wrapped component in the center of the bottom air cushion (see
Figure 6).
Note: The air cushions for the power supply are slightly different in
appearance, but function the same way.
5. Place the top air cushion, plastic side down, over the component (see Figure 7).
When properly installed, the two air cushions suspend the component securely in
the center of the box. These illustrations show a generic component for reference.
6. Close the box and securely tape it shut.
Figure 5 Wrap the component in an anti-static
bag (generic component shown).
Figure 6 Place the component on the
bottom air cushion.
Figure 7 Place the top air cushion over the
component.
To Next Page
Loading...
