Deleting source devices:
In order to totally delete a programmed device use the “Clear” function.
After pressing this function you will be asked if you really want to delete the device.
Conrm this by pressing the “yes” function key. To abort the process press “no”. The remote
control will then return to the Device Selection Menu. Use <exit> to enter the “Learn
Menu”. To leave programming mode press <exit> again.
Renaming the source devices:
If you want to rename a source device you can select a description from a comprehensive
list of pre-programmed device names. Follow the steps described above.
Programming the main keys:
The sound system has 5 main keys (Programme +/-, Volume +/- and Mute), which can be allocated to the IR codes of other infrared-controlled devices. Follow the steps
shown above.
Warning: The Volume +/- and Mute keys can only be used for infrared-controlled devices if no sound system has been registered. The volume control of the sound
system will take priority over all other IR devices.
To Next Page
Loading...
