60
Delete SPECTRAL sound system:
To de-register your remote control from a sound system open the Programme Menu by pressing <exit> and <m> simultaneously, select “RF Learn”
and conrm with <ok>. Select the system you wish to “delete” and conrm your selection with <ok>. Select and conrm the “Clear” function to
continue. Complete the de-registration process by pressing the “yes” function key or abort the process with “no”.
Connecting SPECTRAL sound system:
To register the remote control on a (further) sound system open the Programme Menu
by pressing <exit> and <m> simultaneously. Select “RF Learn”
and conrm this with <ok> . Select “new device” to register a sound system on the
remote control.
After conrmation you will be asked to connect
the sound system to be programmed to the mains power supply and to switch it on.
Wait at least 3 sec., then conrm with <ok>.
Before doing this you should ensure that the sound system had been
disconnected from the mains power supply for at least 1 minute.
The remote control will now try to connect with the newly activated sound system.
A successful connection will be shown in the display as “Installation successful”, while
failure will bring the message “Installation failed”. If the connection
has failed you should identify the problem (device not switched on, distance too great,
sound system not disconnected from the mains power supply
for long enough, etc) and start the process again.
After successful installation you must enter a name for the sound system. If you enter
a name (e.g. BRA1) more than once the remote control will automatically allocate it a
subscript (e.g. BRA1.1, BRA1.2 …). You can then exit the “RF-Learn” menu by
pressing <exit> twice.
If you wish to overwrite an existing sound system, instead of selecting “new device” you
should select the system you wish to replace and conrm your
selection with <ok> . Select the “Learn” function to proceed. Conrm the overwriting
with the “yes” function key or abort the process with “no”.
Continue as previously described under “new device”.
To Next Page
Loading...
