Why does my Spektrum Remote Control receiver loses its bind?
If your Spektrum Remote Control receiver loses its bind, it's possible the transmitter was accidentally put into bind mode, which ended the bind to the receiver. To resolve this, simply bind the transmitter to the receiver again.
Why my Spektrum Remote Control system will not connect?
If your Spektrum Remote Control system fails to connect, several factors could be at play. Ensure the transmitter is 8 to 12 feet (2.4 to 3.6m) away from the receiver and move away from large metal objects. Verify that the correct model memory is selected and bound to the transmitter. If the transmitter was accidentally put into bind mode, rebind it to the receiver. Also, check if the bind plug is installed in the bind port and remove it before cycling power. Lastly, ensure both the vehicle and transmitter batteries are adequately charged, replacing or recharging them as needed.
What to do if Spektrum Remote Control receiver quits responding during operation?
If your Spektrum Remote Control receiver stops responding during operation, it might be due to low battery voltage. In this case, completely recharge the battery. Another potential cause is loose or damaged wires or connectors between the battery and receiver. Inspect these wires and connections, repairing or replacing them as necessary.
General| Modulation | DSMR |
|---|---|
| Proper use | Car, Land vehicle |
| Control type | Steering wheel control |
| Product type | Remote control |
| Product color | Black |
| Frequency band | 2.4 GHz |
| Channels quantity | 5 channels |
| Telemetry receiver | Yes |
| Brand compatibility | Spektrum |
| Number of memory records | 250 |
| Battery type | AA |
| Number of batteries supported | 4 |
Procedure for updating transmitter firmware using the website and SD card.
Adjust servo travel, center, and endpoints for optimal control.
Configure throttle servo position and other channel outputs if radio link is lost.
Process of teaching the receiver the transmitter's unique identifier (GUID).
Calibrate transmitter controls like steering, throttle, and knob.
Access and manage internal model memory locations.
Procedure to bind the receiver to the transmitter for communication.
Instructions for obtaining warranty support and service.
To Next Page
