11-2
7. Connecting the Patient Cable and Electrodes (Applied Part)
8
. Inspections Before Power-On
9
. Login and Account Management
10. Setting Up the Device
I
f you have not purchased a thermal recorder base, device preparation
includes the following steps:
1. Using the Battery
2
. Using the DC Power Source
3. Connecting the Patient Cable and Electrodes (Applied Part)
4
. Inspections Before Power-On
5
. Login and Account Management
6. Connecting the Printer
7
. Setting Up the Device
1
4.3.1 Using the Battery
The device can be powered by a rechargeable lithium battery. When a
battery is installed, the device will automatically run from battery power
in case of power failure of the DC power supply or the recorder base.
Installing the Battery
To install or replace the battery, follow the steps below:
1. Press and slide the battery compartment cover lock/unlock latch to
the unlock position.
2. Push down to remove the battery compartment cover.
3. Place the battery in the battery compartment.
4. Reinstall the battery compartment cover and slide the latch to the
lock position.
Charging the Battery
Because of the power consumption during the storage and transportation,
the battery capacity may not be full, so it is necessary to charge the
battery before using it for the first time.
The battery is charged whenever the device is connected to the recorder
base or a DC power source regardless of whether or not the device is
currently turned on.
W
hen the battery is being charged, the battery indicator illuminates in
yellow. When the device is on, the battery power icon in the upper right
corner of the main screen will dynamically display the charging state of
the battery.
To Next Page
Loading...