2010 Geno/Grinder
Page 25 of 28 SPEX® SamplePrep LLC July 2014
10.0 ACCESSORIES FOR THE 2010 GENO/GRINDER (Cont’d)
Titer Plates and Cap-Mats
While most titer plates can be used in the Geno/Grinder, these sturdy titer plates have been tested
extensively with various samples, and resist perforation by steel grinding balls even at
high clamp speeds. They can be used for many applications including sample
libraries, mother-to-daughter automated plate pipetting, large sample dilutions
and cell suspensions. Suitable for RNA extraction when used with 2600 Cryo-
Station. Titer plates are made of polypropylene, with alphanumeric marks for
well identification. Sold singly or in cases of 100. Cap-Mats seal titer plate wells,
preventing spills and well-to-well contamination. Rugged silicone rubber, may be
sterilized and re-used. Sold singly or in cases of 10.
2200-100 96-Well Titer Plate, Square Wells, Case of 100
Square 2.4 mL wells with a working capacity of 2.0 mL. Case of 100 titer plates.
2201-10 Cap-Mats for 2200 Titer Plates, Case of 10
Sealing mats for the 2200 Titer Plates, above. Case of 10 Cap-Mats.
2210-100 96-Well Titer Plate, Round Wells, Case of 100
Round 2.0 mL wells, rugged polypropylene, alphanumeric marks for well identification. For use with the 2650
Cryo-Block, which is inserted in gaps between wells to keep plates and samples chilled to preserve RNA for
extraction.
2211-10 Cap-Mat for 2210 Titer Plate, Case of 10
Sealing mats for 2210 Titer Plates. Tough silicone rubber, prevents leaks and cross-well contamination. Can be
sterilized and re-used. Sold in cases of 10 mats.
Additional Titer Plates are available. Please visit our website (www.spexsampleprep.com) or see the SPEX
SamplePrep Handbook of Sample Preparation and Handling.
Vials, Vial Sets, and Centrifuge Tubes
Vial sets are an alternative to titer plates. These vial sets are pre-cleaned with grinding balls included. They
come in sturdy carriers that have about the same footprint and height as deep-well titer plates, and fit the
Geno/Grinder Clamp. Vials can be filled and sealed individually, and the larger vials can hold bigger samples
than titer plates. Replacement vials and steel balls can be purchased separately.
2241-PEF Frosted Polyethylene Vial
5 mL frosted polyethylene vial with screw-on polyethylene cap. ½ in. diameter x 2 in. long (12.7 mm x 50.8
mm). Holds one 3/8 in. (9.5 mm) steel grinding ball (2155), fits 2240-PE Vial Set, 2663 Cryo-Block, and 2190 Vial
Rack. Not pre-cleaned. Grinding load per vial 1.5 mL. Sold in units of 240.
2252-PC-30 Polycarbonate 15 mL Centrifuge Tube, Package of 30
15 mL polycarbonate round-bottomed centrifuge tube with screw-on polyethylene cap. Can be used with
2664 Cryo-Block. For use with 2199 Large Capacity Clamp Assembly.
To Next Page