SPEX SamplePrep Geno/Grinder 2010 - Specifications

2010 Geno/Grinder
Page 6 of 28 SPEX® SamplePrep LLC July 2014
2.0 SPECIFICATIONS
Type of Grinder:
Reciprocating, impact grinder
Grinding Mechanism:
Grinding balls of stainless steel. Silica or zirconia beads.
Dimensions
25.25 in. (64.1 cm) high (43 in., 109 cm with top cover open) x
15.00 in. (35.6 cm) wide x 20.49 in. (52.0 cm) deep including
handle, 19.33 in. (49.1 cm) deep excluding handle.
Weight:
87 lbs. (39 kg)
Capacity:
Four standard 96 deep-well titer plates;
sixteen 50 mL or twenty-four 15 mL centrifuge tubes.
Clamp Speed:
Adjustable range: 500-1750 strokes/min.
Clamp Travel:
1.25 in. (3.2 cm)
Electrical
Specifications:
CE approved. Available models: 115V/60Hz or 230V/50Hz.
Fuse:
3AG 8-amp, 250 V slow-blow fuse for 115V/60Hz model.
3AG 5-amp, 250 V slow-blow fuse for 230V/50Hz model
Cord:
115V/60Hz model: 3-prong grounded plug supplied.
230V/50Hz model: 2-prong European plug supplied.
NOTE: Operator is responsible for supplying alternate
line cord/plug if required.
Safety Features:
Lid interlock prevents mill from running if top cover is open.
Timer:
Digital in minutes:seconds, maximum 20:00.
Motor:
1/3 HP. Maximum speed 1800 strokes/min.
Maximum power 450 W.
Environment:
For indoor use only at a maximum altitude of 6600 ft. (2000 m).
Operate at ambient conditions between 40°F (5°C) and 104°F
(40°C), with maximum relative humidity 80% below 88°F (31°C)
decreasing linearly to 50% at 104°F (40°C). Main supply voltage
fluctuations up to 10% of nominal voltage (115 or 230 volts AC
RMS). Pollution degree 1: none or only dry, conductive pollution
occurs.