2010 Geno/Grinder
Page 24 of 28 SPEX® SamplePrep LLC July 2014
10.0 ACCESSORIES FOR THE 2010 GENO/GRINDER
(Available for purchase at additional cost)
A partial list of available accessories is shown here. For a complete listing, please visit our
website (www.spexsampleprep.com) or contact us today for the SPEX SamplePrep
Handbook of Sample Preparation and Handling.
Grinding Balls and Accessories
2100 Grinding Ball Dispenser
Simultaneously dispenses one 5/32 in. (4 mm) steel grinding ball (2150) into each
well of a standard 96-well titer plate, including 2200 and 2210 titer plates.
2110M 24-Pin Magnet
24 magnet-tipped pins on plate with handle. Inserts or removes 3/8 in. (9.5 mm) Steel Grinding Balls (2155)
from titer plates and vial sets. Works with 2230 Titer Plate, 2240-PC and 2240-PE Vial Sets, and 3116PC Vials in
2190 Vial Rack. Used with 2110S Separator.
2150 Grinding Balls 5/32 inch (4 mm)
Made of 440C stainless steel. Used with 2100 Grinding Ball Dispenser and all 96-well titer plates. Sold in bags
of 5,000.
2155 Grinding Balls 3/8 inch (9.5 mm)
Made of 440C stainless steel. For use in 2230 Titer Plate or in 2190 Vial Rack with 3116PC, 2241-PC and 2241-
PE Vials to grind extra large or tough samples. Sold in bags of 100.
Grinding Beads
Molecular Biology Grade Grinding Beads are treated to inactivate contaminating enzymes and have been
tested accordingly. Low Binding Grinding Beads are coated to reduce non-specific binding of nucleic acids and
proteins and are used for lysing dilute samples of cells. Acid Washed Grinding Beads are treated to remove
fine particles and contaminants. They are suitable for most basic applications. SPEX SamplePrep offers all
three grades in sizes ranging from 100 to 1000 µm.
Racks, Clamps, Holders
2190 Vial Rack
Holds 24 3116PC vials, 24 2241-PC vials, or 24 2241-PE vials. All three vials hold a single 3/8 in. (9.5 mm) Steel
Grinding Ball (2155) to grind unusually large or tough samples.
2196-16-PE Holder for 50 mL Centrifuge Tubes
Thick, rugged foam block holds 16 standard 50 mL centrifuge tubes, 115 mm length. For use with 2199 Large
Capacity Clamp Assembly.
2197 Holder for 15 mL Centrifuge Tubes
Thick, rugged foam block holds 24 standard 15 mL centrifuge tubes, 119 mm length. For use with 2199 Large
Capacity Clamp Assembly.
Order any of these
accessories online at
www.spexsampleprep.com
Or call
Customer Service at
855-GET-SPEX or
855-438-7739
To Next Page