10
CUSTOMER CARE
Caution
This machine was designed to be used on a tennis court, platform tennis
court or padel court and in no other circumstances. Only tennis balls,
platform tennis balls or padel balls must be used, no other balls should
be ejected from the machine. Never stand in front of the machine unless
you are on the other side of the net (more than 7 meters (8 yards) away).
Even when the machine is paused, never stand in front of it as balls can
eject at any time. Children should be supervised at all times and taught
never to stand in front of the machine.
Do not use the machine in rain and avoid using wet balls. We recommend
the use of pressureless balls to give your machine the best performance.
Using a combination of new and old balls will give inconsistent results.
Normal pressurized tennis balls are ne to use if all balls are consistent
and have good pressure.
Maintenance
You can vacuum out the inside of your machine to remove ball u.
The outside of the machine can be wiped down with a mild detergent,
however, please be careful not to get water inside the machine. The
throwing wheels should be wiped down after every use to prevent any
buildup of residue from the balls. If you play on a porous surface like clay
or en tout cas, we recommend you wipe the insides of your throwing
wheels monthly (a build up of clay can cause your wheels to become
unbalanced). We also recommend for safety and performance that the
throwing wheels are replaced every 5 years.
Due to vibrations, the screws in the control panel and on the base of the
machine can become loose over time, so please check these regularly
and tighten them if required. If you do need to purchase replacement
control panel screws from the local hardware store, they are 304 Stainless
Steel Phillips Head screws, M4 x 12mm with a 9mm head diameter. You
can contact your local distributor for spares if you need them.
To Next Page
Loading...