21
a brand thoroughly tested and recommended by your distributor (we do
not recommend mixing brands).
Pressureless balls will also allow your machine to perform at its best.
Each ball will have a consistent bounce allowing you to consistently hit
the spots on the court that you want. Normal pressurized balls go at
quickly when used in conjunction with a ball machine.
Low Compression Balls
Our machine can handle both orange (stage 2) and green (stage 3) low
compression balls. It cannot work with red (stage 1) balls due to their
larger size.
HIDDEN FEATURES
Manual Mode
If you experience any alignment (eg, shooting too far to the right) or
initialization (HCAL or VCAL errors) issues, it is likely you can resolve
them by starting the machine in manual mode. To do this, please follow
these 3 steps:
Make sure your machine is turned o (you may need to use the master
switch under your machine).
Manually move the internal mechanism of your machine to the lowest
possible elevation and to the center of the opening.
With the master switch on, hold both the POWER and MENU buttons
at the same time for 5 seconds to turn on your machine. The LCD
should display a message to let you know you have entered “manual
mode”.
The above steps can be seen in this video: https://goo.gl/C6zB3J
- Note, this video shows the process on the v1 machine, but it’s the same
steps for the v2. If this resolves your problem, then you can continue to
use your machine this way until a permanent solution can be obtained
from your Spinre dealer. Please note that this solution relies on you
1.
2.
3.
To Next Page
Loading...