Key Type Value Description
UltracalOff B true = disable frame calibration
default = false
A.5.4.2 CHR - read/write cross hair location
This command is valid only when cross hair is set to manual (see :DIS). The range of allowable
values is returned by the WLD? command.
:CHR <configuration>
Key Type Value Description
X F x location in world coordinates
5
Y F y location in world coordinates
5
Cursor B true = snap the cross hair to the location of
the cursor. Any X or Y values in the same
command are ignored.
default = false
:CHR?
Returns:
CHR <configuration>
2
If cross hair is set to centroid, peak, or origin then returns centroid, peak, or origin location
respectively. Otherwise returns manual cross hair location.
A.5.4.3 CUR - read/write cursor location
This command is valid only when cursor is set to manual (see :DIS). The range of allowable
values is returned by the WLD? command.
:CUR <configuration>
Key Type Value Description
X F x location in world coordinates
5
Y F y location in world coordinates
5
:CUR?
Returns:
Operator’s Manual LBA-PC
242
CUR <configuration>
2
To Next Page