20
Source selection
The Phonitor is not just a headphone monitor amplifier. It is also a preamplifier three audio sources, XLR,
XLR and RCA.
The chosen source feds he headphone output on the front as well as the XLR audio outputs
on the rear of the Phonitor.
Output selection
With the Output switch () you send an input signal to a selected output – headphones or
loudspeakers (XLR audio outputs on the rear).
In the Mute position no signal passes through to the outputs. The VU meter are illuminated in red.
Warning: Never connect a mono jack cable to the headphone output (front panel stereo jack). Make sure
that the stereo jack is fully inserted, otherwise a short circuit might damage the headphone amplifier!