28
Outputs
Headphone output
Warning: Never connect a mono jack cable to the headphone output (front panel stereo jack). Make sure
that the stereo jack is fully inserted, otherwise a short circuit might damage the headphone amplifier!
• . mm TRS connector
• Pin wiring: Tip = Left, ring = right, sleeve = GND
• Impedance: . ohm
• Attenuation factor: @ ohms
• Frequency range: Hz to kHz ( - dB)
• Crosstalk at kHz: - dB
• THD & N: .% (at dBu, kHz, kohms load)
• Noise (A-weighted): - dB
• Dynamic range: dB
To Next Page
Loading...
