Date of issue: March 2016 Revision 2 Page 36/80
- Once the product has reached the desired
consistency the LEDs will stop flashing and the
rotation of the beater will stop.
- To dispense, place a glass under the tap and
pull the lever as shown in fig. 16. The beater
will begin to rotate again, starting the
dispensing phase.
- When the product level LED D (fig. 17) is lit, it
means that the product level in the top tank is
low and should be refilled; in these conditions
the appliance is forced to work at the minimum
level of consistency until the product level has
been restored.
!ATTENTION!
Failure to restore the product level can cause
serious damage to the appliance.
Fig. 16
Fig. 17
To Next Page
Loading...
