Date of issue: March 2016 Revision 2 Page 35/80
- Place the fixing bracket on the pump pressure
pipe (fig.12).
- Pour the remaining product into the upper
tank.
- Replace the cover on the tank, insert the plug
and turn on the main switch A (fig. 13).
- Select the desired mode of operation from the
control panel (fig. 14)
- To activate the cooling system in cooling mode
push the power button B on the control panel
(fig. 15).
!ATTENTION!
On pushing the power button the cooling system
comes into operation. To prevent the appliance
being damaged, always make sure you have
already introduced the mix into the tank before
activating the cooling system. Never activate it
with the tank empty.
- To change the consistency of the mix, press
the + and
–
keys of the control panel (fig. 15).
Pressing + will cause the number of LEDs lit to
rise and consequently the consistency setting
increases. Pressing
–
instead will decrease the
number of LEDs lit and reduce the mix
consistency (fig. 15).
- If the
–
key is pushed until all three
consistency LEDs go out, the appliance will go
into defrost mode. This mode will be indicated
by the fact that only the LED of the power
button B is lit.
- To activate wash mode, push the button
WASH button (button C in fig. 15) after
switching off the cooling system by pressing the
power button B and making sure that its LED is
off.
NOTE: when the consistency LEDs flash, it
means that the cooling system is operating as
the consistency setting has not yet been
reached.
Fig. 12
Fig. 13
Fig. 14
Fig. 15
To Next Page
Loading...
