SPM U-go - Page 41

Date of issue: March 2016 Revision 2 Page 41/80
- Remove the device that gives the star-shaped
form to the ice cream from the flange (fig. 31).
- Extract the beater and all components
mounted on it (fig. 32).
- Dismantle the beater as shown in fig. 33 and
30, taking care to remove all the components
listed below:
• Central shaft L (fig. 33);
• Two scrapers N (fig. 33);
• Both the two rear seals M and O (fig.
30).
- Dismantle the two rear seals M and O into its
two component parts, the bushing and the
rubber cup gasket (fig. 34).
- Wash each of these components thoroughly
with hot water and washing-up liquid.
Fig. 30
Fig. 31
Fig. 32
Fig. 33
Fig. 34