SPM U-go - Page 42

Date of issue: March 2016 Revision 2 Page 42/80
- Remove all components inside the top tank as
shown in fig. 35:
E – floating product level;
G – mixing impeller.
- Wash each of these components thoroughly
with hot water and washing-up liquid.
- Remove the drip tray by pulling it gently
outwards (fig. 36) and wash it thoroughly with
hot water and washing-up liquid.
ATTENTION
Never carry out washing operations in a
dishwasher as these components may be
severely damaged in it.
- Rinse well and dip each piece in the sanitising
product according to the doses and immersion
times suggested by its manufacturer.
- Once the correct times for sanitising have
been followed, thoroughly rinse all components
with clean water and dry with a clean cloth.
- Wash the freezing cylinder and top tank
thoroughly, removing any remaining product
with a clean sponge soaked in sanitizer and
spray sanitizer on all these surfaces leaving it as
suggested by the manufacturer (see fig. 37).
Fig. 35
Fig. 36
Fig. 37