44
MAINTENANCE
LUBRICATION:
The treadmills have already been spread with "Silicone Oil" in advance before leaving the manufacturing plant. Silicone oil
is without volatility and has gradually permeated through the running belt.
Lubrication must be applied all 50 working hours.
NOTE: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any other oil
ingredient; otherwise the treadmill will be damaged. Do not over-lubricate the walking board. Excess
lubricant should be wiped off with a clean towel.
TROUBLESHOOTING GUIDE
Problem Possible Causes Note
E01 Console communication failures Drives do not receive a digital signal
E02 Motor failure
E03 Speed sensor failure With inductive drive
E04 Motor Circuit disconnection
E05 Over current protection
E06 The supply voltage is too low
E07 Check the safety lock
To Next Page
Loading...
