SPORTSTECH sTread Lite - 11 Cleaning, Maintenance and Care; Cleaning Your Device; Device Maintenance; Device Servicing

49
DE
EN
11. Cleaning, Maintenance and Care
11.1 CLEANING YOUR DEVICE
• Wipe sweat from the machine with a damp cloth after each use.
• Do not use abrasive cleaners or solvents to wipe down the machine.
11.2 DEVICE MAINTENANCE
Before and after each use, you must check that the machine is in good working condition. Use the
following procedure:
• Inspect the machine to make sure it has all the necessary parts.
• Check that all protective covers and mounting hardware are intact and in place.
• Verify that all fasteners are tight. Tighten any loose screws immediately.
• Before each workout, check that the safety clip is in proper working order as follows:
- Stand on the sides of the machine.
- Start the treadmill at a slow speed.
- Pull the safety clip out of the console. The treadmill should stop immediately and not restart.
11.3 DEVICE SERVICING
For proper operation and long life, the treadmill belt must be adequately lubricated with silicone
oil. Thin tubes are located on the bottom of the machine to act as a lubrication system.
Lubrication and Inspection Intervals
• Refill with silicone oil after the first 25 hours of operation (or 2-3 months).
• Check lubrication regularly.
• Add silicone oil at least every 50 hours of operation (or 5-8 months).
Checking the Lubrication
• Make sure the power plug is unplugged.
• Lift the belt on one side. Run your finger over the top of the deck under the belt.
- If the deck feels slightly oily, lubrication is adequate.
• Add silicone oil if the deck feels dry.
Caution: Do not allow moisture to enter electrical or electronic components.
Note: Use ONLY silicone oil to lubricate the running belt.
Warning: Do not operate the machine unless you are certain that it is not defective or
incomplete.