To Next PageTo Next PageWhat to do if my SprayTECH Water Pump will not run?
If your SprayTECH Water Pump won't run, first ensure the unit is plugged in and the breaker hasn't tripped; if tripped, reset it. Check that the pressure control knob isn't set too low; turn it clockwise to increase the pressure setting. Finally, inspect the wiring; if you suspect faulty or loose wiring, take the unit to a SprayTECH authorized service center.
Why does my SprayTECH Water Pump have a poor spray pattern?
A poor spray pattern from your SprayTECH Water Pump could be due to several reasons. The spray tip might be worn or too large, so replace it following the instructions. The pressure may be excessive; rotate the pressure control knob counterclockwise to decrease it. Also, the spray tip could be too large for the material you're using, so replace it with a new or smaller one. Incorrect pressure settings can also cause this issue; adjust the pressure for a proper spray pattern. Insufficient fluid delivery might be the cause, so clean all screens and filters. Lastly, the material being sprayed might be too viscous; add solvent according to the manufacturer's recommendations.
General| Brand | SprayTECH |
|---|---|
| Model | EPX2355 |
| Category | Paint Sprayer |
| Language | English |
High pressure fluid can pierce skin, causing severe injury or amputation. Seek immediate medical attention.
Inhaling or contacting paints, solvents, insecticides can cause nausea, fainting, or poisoning.
Solvent and paint fumes can explode or ignite, leading to property damage or severe injury.
Certain materials can cause explosion or severe injury when mixed with incompatible substances.
Proper grounding reduces the risk of electric shock during operation.
Lists common problems encountered during operation and their solutions.
