Important!
. @
• Transport the unit in an upright position only, or leave it in an upright
position for at least 2 hours before first use.
• Always place the unit on an even surface (Figure 1).
• Make sure the unit is connected to a correctly grounded power supply
(refer to the rating label located at the back of the unit).
• An opening in a window or walt is required to accommodate the
exhaust hose (kit supplied) to expel the warm air.
• Do not cover or obstruct the appliance inlet or outlet grilles (Figure 2)+
• To avoid the risk of shock, the product should never be used in
bathrooms, shower rooms or in any other steamy or wet areas.
• The unit will cool when the room temperature is between 62"F and 110°F
depending on the thermostat setting.
• Do not sit or place objects on the unit:
• Do not touch the unit With wet/damp hands or when standda_gbarefoot.
• Avoid all contact with +chemical based materials.
The filter must be used with the product at all times. When removing for
cleaning, always disconnect the unit from the mains first.
• Turn off the appliance when not in use.
• At the end of each season all water must be drained and the unit and
filters cleaned before storage.
Drainage of the water container is required before moving the unit or
putting it into storage,
If the electric socket is different from the plug provided, have a
professionally qualified electrician replace the plug with a suitable one.
Avoid the use of adaptor plugs, multiple sockets and/or extension leads;
if their use is necessary, ensure that they conform to the current safety
regulations.
Do not pull the supply cable or place it near a source of heat; always
unroll it completely to avoid the possibility Of dangerous overheating.
If the supply cord is damaged, it must be replaced by the service agent
or a similarly qualified person.
THE MANUFACTURER DISCLAIMS ANY RESPONSIBIIATY IF THE
ABOVE INSTRUCTIONS ARE NOT FOLLOWED.
Fig.t
4
To Next Page
Loading...
