© 2021 Radiodetection Ltd 10
(8200G model) or select an
external GPS source
Select metric or imperial units
Enable or disable utility selection
Utility Selection – Only visible if
utility section is active
Select local power network
frequency: 50 or 60Hz
Enable or disable antenna modes
Enable or disable individual
frequencies
Enable or disable StrikeAlert
Set battery type: Alkaline, NiMH or
Li-Ion
Select NULL or proportional
Guidance (GUIDE) arrows in
Peak+ mode
Enable or disable display of the
Compass feature
Enable or disable vibrating handle
warnings
Set audio tone frequency level
high or low
Enable or disable Swing warning
Run a Self-Test, show the locator
software version and revision,
display the date of the most recent
service recalibration (CAL) or the
most recent eCert calibration
(ECERT)
CD Reset (when in CD mode)
Table 3.1 Locator menu options
Navigating the transmitter menu
1 Press the key to enter the menu
2 Use the or keys to scroll through the menu
options
3 Press the key to enter the option’s submenu.
4 Use the or keys to scroll through the
submenu options
5 Press the key to confirm selection and return to
the previous level or exit the menu
6 Press the key to return to the main operation
screen
Transmitter menu options
Adjust the speaker volume from 0
(mute) to 3 (loudest)
Enable or disable individual frequencies
Boost transmitter output for a specified
period of time (in minutes)
Run SideStepauto™ to auto-select a
locate frequency for the connected
utility
Set battery type: Alkaline, NiMH or Li-
Ion. Select Eco mode (alkaline batteries
only)
Set the transmitter to output its
maximum wattage.
Match the transmitter setting to the
model of your locator (see Appendices
for a list of all available models)
Set the output voltage to maximum
(90V)
Enable, disable or pair Bluetooth
connections (TX10B model only)
Show the transmitter software version
and revision
Table 3.2 Transmitter menu options
To Next Page
Loading...
