Spypoint CELL-LINK Series - Preparation; Power Source Options; Battery Installation; MicroSD Card Management

ENGLISH
4
PREPARATION
SELECT A POWER SOURCE
• Lithium or alkaline AA batteries (follow order/polarity indications)
• 12V rechargeable battery (#KIT-12V)
• 4.2V rechargeable battery pack (#LIT-10)
FOR BEST RESULTS AND NO LEAKAGE:
• Use only new lithium or alkaline batteries.
• Do not mix old and new batteries.
• Do not use rechargeable batteries (their lower voltage can generate operational issues).
HOW TO INSTALL AA BATTERIES PROPERLY
• Unlock and open the CELL-LINK door.
• Take the battery holder out.
• Insert the AA batteries into the battery holder following polarity (+) and (-) indications.
• Place the battery holder back into the battery compartment.
• Make sure you hear a click when inserting the battery holder into the compartment.
FORMATTING YOUR M
icro
SD CARD
Before inserting the MicroSD card into your CELL-LINK, it must be reformatted via
a computer to ensure proper functionality.
Memory card is sold separately. Whether you choose to use a MicroSD card you
previously used in another device or a brand new one you've just bought, its
capacity must not exceed 32 GB and it must be reformatted. Do no use the "Quick
format" option.
INSERTING A M
icro
SD CARD
• Ensure the CELL-LINK is turned o and open its door.
• Insert a MicroSD memory card (up to 32 GB capacity) into the MicroSD
card slot with the label facing up.
• The card is inserted correctly when a click is heard.
NOTE:
We recommend using the SPYPOINT #LIT-10
rechargeable lithium battery pack, sold separately.