18
FORCE-PRO-SSPYPOINT
PROBLEMS POSSIBLE SOLUTIONS
IMPOSSIBLE TO TURN THE CAMERA ON
1. Check if the chosen power source is fully charged.
2. If using AA, ensure they are correctly installed
3. Replace AA batteries
4. Install the latest update (available on www.spypoint.com under the SUPPORT section).
THE CAMERA'S SCREEN SHUTS OFF
Turn OFF the camera and turn it ON again.
THE CAMERA IS NO LONGER RESPONDING
1. Turn OFF the camera and turn it ON again.
2. If using AA, remove them and reinsert them.
THE CAMERA DOESN’T TAKE PICTURES/VIDEOS
1. Make sure the camera is turned ON.
2. Check if there are batteries in the camera.
3. Replace the batteries.
4. If it is not already done, remove the protective sticker
on the detection lens of your camera.
5. Format the SD card. Do not choose the “Quick format” option.
6. If none of the previous solutions works, reset the
camera and the settings.
BLURRY PHOTOS
Low-lighting conditions and fast-moving subjects may produce streaks on the photo;
try setting the “Night mode“ to “Min blur“.
THE RED LIGHT IN FRONT OF THE CAMERA FLASHES
1. During the installation, the delay light ashes for 30 seconds to allow the user
to walk away without being photographed.
2. The camera is in TEST mode and detects movement.
Troubleshooting
To Next Page
Loading...
