Spypoint LINK-MICRO - STARTING THE CAMERA; Operation and Troubleshooting

9
ENGLISH
STARTING THE CAMERA
We recommend formatting your MICRO SD card if it was used in another electronic
device.
• Turn on the camera (ON button);
- Use the OFF/ON switch to turn on the camera;
• The green “status” light ashes – searching for a signal;
- The signal search can take a few minutes;
• Light “status”: One of the following 3 colors will light up continuously:
- Red: insufcient signal;
- Orange: acceptable signal;
- Green: optimal signal;
• When the top right light ashes red, 30 seconds remain before the
photo mode is turned on;
• The camera is ready for use when all the lights turn off;
• If the light is red during step 3, you should:
- Turn your camera off and then back on;
- Retry while pointing the antenna at different angles;
- Move the camera.
*Using an amplied antenna (#CA-01, not included) could improve
signal capture.
