SRAM code rsc 2018 User Manual

36Piston Assembly Installation
Piston Assembly Installation
NOTICE
DOT fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (e.g. your frame) or printing on the brakes, wipe it off
immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT fluid is not covered under warranty.
Submerge a new piston in SRAM® High-Performance DOT 5.1 fluid.
You can also use SRAM DOT Assembly Grease, or DOT 5.1 or 4
compatible grease, as a lubricant.
Install the new piston assembly into the lever body.
Clean the lever body.
Install the washer on the piston assembly.
Push the piston assembly into the lever body and secure the snap ring
in its groove. Orient the snap ring eyelets opposite the opening in the
lever body.
Use a 10 mm deep socket against the snap ring to push the piston/
washer/snap ring assembly into the lever body and insure it is seated
in the lever body..
DOT 5.1 Fluid Torque Spec 22 mm
1
2
3
Internal Snap Ring Pliers Torque Spec 22 mm
4

SRAM code rsc 2018 Specifications

General

Brand	SRAM
Model	code rsc 2018
Category	Bicycle Accessories
Language	English