25Caliper Piston Removal
Caliper Piston Removal
NOTICE
DOT fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (i.e. your frame) or printing on the brakes,
wipe it off immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT fluid is not
covered under warranty.
Use an 8 mm open end wrench to remove the banjo bolt.
Set the hose and banjo fitting aside.
Use a T25 TORX® wrench to remove the caliper body bolt.
Separate the caliper body halves.
1
8 mm open end wrench Rubber-tipped blow gun chuck nozzle 22 mm
T25 TORX wrench Rubber-tipped blow gun chuck nozzle 22 mm
2
3
To Next Page
Loading...
