38crimped hose fitting
Use an 8 mm line wrench to install the crimped hose fitting into
the caliper hose port.
Insert the bleed block into the caliper.
NOTICE
You will need to bleed your brakes before reinstalling the brake
pads.
Spray isopropyl alcohol on the caliper and clean it with a rag.
Visually check your work. If an o-ring protrudes from the crimped hose fitting, remove and replace the o-ring, then repeat the
installation process.
⚠ CAUTION
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions, visit www.sram.com/service.
8
8 mm line wrench 9.7-11.7 N·m (86-104 in-lb) T25 TORX®
9
10
To Next Page
Loading...
