SRAM level ultimate - Page 10

10Caliper Piston Removal
Firmly press a rubber-tipped air chuck nozzle into the banjo port. Hold
the caliper securely against a rubber surface and force air into the
banjo port to dislodge the piston from the caliper.
⚠ CAUTION - EYE HAZARD
Wear safety glasses.
The caliper piston may dislodge rapidly from the caliper, which can lead
to bodily injury or damage to the parts. Point the caliper piston toward a
rubber surface to prevent the piston from becoming a projectile.
Remove the pad retainer bolt, then remove the SRAM piston removal
tool from the caliper.
Insert the Level piston plug so that it fits snugly into the empty piston
bore and is flush with the inside of the caliper.
3
T25 TORX wrench Rubber-tipped blow gun chuck nozzle 22 mm
4
Level piston plug 20 mm or 15 mm Thru Axle
5