SRAM level ultimate - Page 22

22Caliper Piston Installation
Use a pick to remove the o-ring from the crimped hose fitting.
Apply a small amount of DOT 5.1 fluid to the new o-ring and
install it.
Align the caliper body halves together, then thread the caliper body
bolts into the caliper by hand.
Use a torque wrench with a 5 mm hex bit socket to tighten each bolt to
9.8-11.8 N·m (87-104 in-lb).
Use a T10 TORX® wrench to install the bleed screw.
4
5
6
5 mm hex 9.8-11.8 N·m (87-104 in-lb) T25 TORX®
7
T10 TORX wrench 9.8-11.8 N·m (87-104 in-lb) T25 TORX®