St George CC29/E - Using the Appliance for the First Time; Burning-In (CB35 BBQ Grill Model)

USING THE APPLIANCE
FOR THE FIRST TIME
2. USING THE APPLIANCE FOR THE FIRST TIME
After installation remove all notification
labels (not gas or electrical warning labels), advertising, tape, packaging,
etc. A quick
diluted wash with Ammonia and water should rinse away any adhesive residue. Eucalyptus
oil (small
amounts) is also good for removing adhesive residue. Thoroughly rinse cleaned surfaces
and wipe them dry using
a clean, soft cloth.
Before using the BBQ grill (CB355 BBQ Grill
Model) make sure the volcanic rocks are removed from their
wrapping and place them into the removable
grill tray.
Before using
the ceramic glass cooktop (ceramic cooktop models only) clean it thoroughly with a suitable
cooktop
cleaner (e.g. Hillmark Ceramic Cooktop Cleaner) and rinse with a clean, warm, damp
cloth or paper towel. To
avoid cooked on cleaner residue, wipe
the glass dry with a soft cloth or paper towel.
NOTE: People with sensitivity to cleaning chemicals
must take the necessary precautions. It is recommended that protective
gloves be worn while cleaning the appliance.
2.1 Burning In (CB35
BBQ Grill Model)
Before cooking with the appliance an initial pre-heat
is required to burn off the fine oil film used to protect the
elements during shipping. The first time you heat
up the elements the oil will be given off as smoke (some smell
may also be noticeable), which is perfectly
normal.
Turn the
BBQ grill controls to Hi and leave for approximately 1 0 minutes or until the smoke has disappeared.
After completing the above turn all controls off. The cooktop is now ready for grilling.